CUSTOMER REQUESTS MAINTENANCE AND MULTI-POINT INSPECTION.
SET TIRE PRESSURES TO MANUFACTURER SPECIFICATION
ROTATE TIRES
Technician was able to duplicate concern appears sunroof is binding and getting caught on rail system when trying to open. Recommend customer to have body shop take a look at sunroof concern, possible chance they may have to remove entire sunroof assembly and that will require body shop experience due to headliner and body being involved.
FOUND ENGINE AIR FILTER DIRTY. REPLACED ENGINE AIR FILTER
FOUND CABIN AIR FILTER DIRTY. REPLACED CABIN AIR FILTER
JOHN R. gave our service a 5 star review on 11/19/2023
TECHNICIAN VERIFIED CUSTOMERS CONCERN. FOUND FRONT AND REAR BRAKES WORN DOWN TO MINIMUM THICKNESS . FRONT BRAKES MEASURE AT 2.5MM AND REAR BRAKES MEASURE AT 3MM . RECOMMEND TO REPLACE THE FRONT AND REAR BRAKES COMPLETE. ** NOTE ** RECOMMEND TO REMOVE THE BRAKE MASTER CYLINDER TO VERIFY HEALTH OF JUNCTION SEAL.
CUSTOMER REQUESTS ENGINE OIL SERVICE.
Hazardous Waste Disposal Fee
Hazardous Waste Disposal Fee
CUSTOMER REQUESTS MAINTENANCE AND MULTI-POINT INSPECTION.
SET TIRE PRESSURES TO MANUFACTURER SPECIFICATION
FRONT BRAKE SERVICE
REAR BRAKE SERVICE
MASTER CYLINDER – Remove & Replace – S,SE,SEL,In-Line4,Automatic Trans – [Includes: Bleed Brake System. NOTE: Deduct .4 when used in conjunction with any other Brake operation(s).]
Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
JAMES K. gave our service a 5 star review on 5/30/2023
AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Turbocharger,2.0L Eng Right Side – [Includes: Replace Transmission Output Seal.] – [NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
CONTROL ARM – Remove & Replace – Turbocharger,2.0L Eng Lower,Both – [DOES NOT include alignment.]
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
STABILIZER BAR CONTROL LINK – Remove & Replace – Both Sides
SET TIRE PRESSURES TO MANUFACTURER SPECIFICATION
TIM G. gave our service a 5 star review on 3/19/2022
Includes : Change oil and oil filter. Lube all fittings on steering linkage, ball joints & drive shaft(s). Check and correct all fluid levels to include power steering fluid, coolant, battery acid (unless battery sealed), automatic transmission fluid. Inspect brake fluid. Check tire pressure. Install "Next Service Due" sticker.
Hazardous Waste Disposal Fee
TECHNICIAN INSPECTED VEHICLE AND NOTED NOISE WHEN REVERSING. NOTED THAT REAR BRAKE PADS WERE LACKING SUFFICIENT LUBRICANT. TECHNICIAN RE-LUBED REAR BRAKES AND TESTED. NOISE IS GONE AT THIS TIME. IF SYMPTOMS PERSIST, RETURN TO SHOP – REAR BRAKES MAY REQUIRE REPLACEMENT AS SOME PLAY IS NOTED.
SET TIRE PRESSURES TO MANUFACTURER SPECIFICATION
GRETCHEN M. gave our service a 5 star review on 11/3/2021